Mitsubishi M700/M800

Mitsubishi M700 / M800 dialog

param

Enable Mitsubishi (M700/M800)

Check this field to enable the Haas M-Net monitoring.

param

CNC name or IP address

Use this field to specify the CNC host name or IP address.

param

Ping before connecting

Check this field to limit the TCP/IP connection load by pinging the device before attempting to open the COM port.

If the device does not respond to a ping message no attempt is made to open the port.

param

Log message when port starts

Check this field to generate a message when the port starts.

param

Cycle On

Use this field to specify the message generated when the cycle is on.

param

Cycle Off

Use this field to specify the message generated when the cycle is off.

param

Alarm On;

Use this field to specify the message generated when the control goes into alarm.

param

Alarm Off

Use this field to specify the message generated when alarm stops.

param

Feed hold On

Use this field to specify the message generated when feed hold on.

Feed hold includes single step etc.

param

Feed hold Off

Use this field to specify the message generated when feed hold is off.

Feed hold includes single step etc.

param

Program changed

Use this field to specify the message generated when program changed.

param

M30 Counter #1

Use this field to specify the message generated when M30 Counter #1 changes

Overrides

Spindle speed

Feed rate

Rapid feed

param

Enable control modes

Check this field to enable control modes.