End of loop

Use this dialog to specify any data that should be sent at the end of a looped transmission.

Note: The last file in a looped transmission uses the regular end of feed information specified on the End Of Feed sheet, including end trigger and any feed data specified.

End of Loop dialog

param

Use regular end of feed information for end of loop

Check this field if you want to use the data specified on the 'End of feed' sheet, after each loop, of a looped transmission.

This includes both the end trigger and any feed data.

When this field is checked, all other fields in the dialog are disabled.

param

End loop at line containing

Use this field to specify the end of loop trigger. When the end of loop trigger is found, the server will proceed to send the file again, unless it is the last file in the loop.

If this field is left empty, transmission will continue until the end of the file.

For further information on how to specify triggers, please refer to [LINK:triggers].

Note: The last time a file is transmitted during a looped transmission, the end trigger specified on the End of feed sheet is used.

param

Send data after end of loop

Check this field if any data should be sent.

param

No translation of feed data

Check this field if the 'Transmit translator(s)' should not be applied to the feed data.

param

Send trigger mode

Use this field to specify how the trigger line should be sent.

param

Send linefeed after trigger line

Check this field to send the linefeed sequence, specified on the 'Transmit' sheet, after the line containing the trigger.

param

Ignore end triggers inside comments

Check this field to ignore end triggers inside comments, or after block skips.

Send at end of loop

Use these fields to specify data that should be sent after a file in a loop transmission is transmitted.

Note: After the last file transmitted during a looped transmission, the data specified on the End of feed sheet is used.

Data is sent in this order:

param

Send file

To send a standard end of loop file, enter the filename in this field, or press the folder button and select the file.

Note: If you are using remote administration, use the folder button to select a file, do not specify a filename manually.

param

Send data

Use this field to specify any data that should be sent. Data can contain environment variables like $ACTIVETOOL etc. Please refer to the online documentation for a complete list of available environment variables.

param

Send character

Use this field to specify a character that should be sent one or more times.

param

Send number of times

Use this field to specify the number of times that the selected character should be sent.