Heidenhain Opt18

Heidenhain Opt18 dialog

param

Enable Heidenhain Option 18

Check this to enable support for Heidenhain Option 18

param

Heidenhain Opt18

Check this to use Heidenhain OCX3

param

Use only Heidenhain Messages

param

Write Log File (Only for Debugging)

Check this to write Log Files, only use it for debugging.

param

TCP port

Use this field to specify TCP port.

param

Machine address

Use this field to specify Machine address.

param

Ping before connecting

param

Cycle On

Use this field to specify the message generated when the cycle is on.

param

Cycle Off

Use this field to specify the message generated when the cycle is off.

param

Alarm On;

Use this field to specify the message generated when the control goes into alarm.

param

Alarm Off

Use this field to specify the message generated when alarm stops.

param

NC Event

Use this field to specify NC Event.

param

Program changed

Use this field to specify the message generated when program changed.

param

M30 Counter #1

Use this field to specify the message generated when M30 Counter #1 changes

param

Feed hold On

Use this field to specify the message generated when feed hold on.

Feed hold includes single step etc.

param

Feed hold Off

Use this field to specify the message generated when feed hold is off.

Feed hold includes single step etc.

param

Enable control modes

Check this field to enable control modes.

Overrides

Spindle speed

Feed rate

Rapid feed

param

Enable control modes

Check this field to enable control modes.

param

Panel Option