Backplot

Use this dialog to configure general backplot settings.

To configure the Backplot settings, select Backplot from the File types menu in the left window of the Editor Setup dialog, or click the Backplot Setup icon in the File menu within the Backplot tab. The following dialog appears:

Backplot Setup dialog.

Only the backplot options for the selected file type are active. All other options are grayed out.

Backplot Setup

param

Control Type

Select the control type for the backplot from the list.

param

Tool Library

Use this button to set up the tool library for the selected control type. Information on how to set up tools is found under Tool.

param

Diameter programming

Check this field to select diameter programming.

param

Arc center is specified as diameter

Check this field to select diameter programming for arc centers also (I coordinate).

param

Draw 'zero' arcs

Check this field if a full circle should be drawn on arcs with the same start and end-point.

param

Show cycles

Check this field to plot cycles.

param

Ignore M6

Check this field to ignore tool load commands (like M6).

You can specify the tool load command on the Machine setup page.

param

Ignore tool number 0

Check this field to ignore tool number 0. This is useful if T0/T00/T0000 is used to cancel the length offset.

param

Enable 4/5-Axis plot

Check this field to enable 4/5-Axis backplotting.

param

X100 = X0.100

When this option is selected, the program will assume that a value without a decimal separator is 1/1000 of a regular move.

param

Disable radius compensation

Check this field to disable tool radius compensation.

param

Use shortest angle moves

Check this field to use the shortest angle.

Example: When moving from 359 degrees to 1 degree, the simulation will normally move 358 degrees back. When this option is checked, only a 2 degrees move is performed.

param

Use U/V/W relative moves

Check this field if U/V/W should be used as relative moves.

param

Arc type

Select the type of arc that is used from this drop-down list.

param

Orientation

Use this field to specify the orientation of the plot for turning operations.

param

Solid animation options

Use this field to select if the solid animation should be performed as a normal or New OpenGL three dimensional visualization (3D milling and turning) or as a two dimensional simulation (2D turning).

New OpenGL is only enabled if the supported OpenGL version is equal or higher than 3.3 and the Graphics card is NVidia: GeForce, Quadro, NVS or ATI: Radeon, FirePro. All other graphics cards will by default use "Solid Animation" which supports OpenGL version 1.1 or higher.

The two-dimensional simulation is only available for turning routines.

param

Machine Setup (4/5-Axis)

Use this field to specify the machine type. The machine type/geometry is important for 5-Axis simulation. Click on the icon next to the field to edit the machine configuration.

param

Keyboard / Mouse mapping

Select the keyboard mapping from this list.

param

Map letters (Ex. 'A=WB, B=WA, I=J, J=I' )

Use this field to map the default letters to a different string.

Example: If a CNC uses XA for A-axis rotation, specify A=XA in this field.

Example: If a machine has switched the X and Y axis, specify X=Y, Y=X.