Use the following dialog to configure basic receive settings.
[PIC:setup_dd11_receive:Receive settings.]
Check this field to disable transmission of files from the CNC to the DNC server.
This will prevent the operator from accidentally overwriting files on the server.
When this field is checked, the server will scan all the directories specified on the Request directories setup sheet. If a file with the same name as the received file is found, that file will be replaced with the received file.
Note: To backup the existing file, you must configure backups. For further information, please refer to [LINK:pcfg_lsv2_deckel11_backup].
When a file is received from the CNC, and the Replace if found in request directories is not checked, or the received file is not located in any of the directories specified on the Request directories setup sheet, it will be saved in the directory specified here.
This field shows the actual path for the directory specified above, with any environment variables expanded.
Check this field if you wish to save failed transfers.
Failed transfers occur if a communication error was detected during the file transfer.
Specify the number of failed transfers to keep.
Failed transfers are named $FAILED\\FAILED_$PORTNAME.xxx.
The file with the largest xxx value is the latest failed transfer.
Use this field to specify where received macro programs should be saved
Check this field to save macro programs in a separate directory.
Use this field to specify where received macro programs should be saved.
This field shows the actual path for the directory specified above, with any environment variables expanded.