Translators

Use this dialog to configure character/string translations.

Translators dialog

param

Trigger

Use this field to specify the trigger that should be translated.

param

Operation

Use this field to specify the operation that should be performed on any triggers found in the transmitted data: 'Remove', 'Replace', 'Upper case', 'Lower case' or 'Remove white spaces'

param

When

Use this field to specify where the translator should be applied: 'Always', 'Inside comments', 'Outside comments', 'At the beginning of lines' or 'At the end of lines'

param

Count

Use this field to specify how many times the selected translator should be used.

Example: If you specify 2 in this field, the translator will only be used the first 2 times it finds a match.

Specify a negative value to skip matches.

Example: Specify -2 in this field if the translator should not be applied the first 2 times it matches a line.

param

Replace with

Use this field to specify the string that should replace any occurrences of the specified trigger.

If the trigger is specified using the advanced format, you can insert the trigger using '#'.

Example: To ensure that all tool changes are followed by M6, specify '' as trigger, and '# M6' as the replace string.

param

Message

Test translators

param

Test data

Use this field to test the specified translators.

param

Result

This field show the result of applying the specified translators to the test line specified above.