Report failed request

Use this dialog to configure the receive report send after a failed receive operation.

Failed request reports are send if a valid remote request was received, but the requested program could not be found.

Report failed request dialog

Receive Report Settings

param

Send report after failed remote request.

Check this field to enable reporting of failed remote request. This report will be sent if a valid remote request was received, but the requested program could not be found.

param

Send in comments

Check this field if the receive report should be sent as comments. You can specify the format of comments on the 'Machine Type' setup sheet.

param

Send with block numbers

Check this field if the receive report should be sent with block numbers. You can specify the format of block numbers on the 'Machine Type' setup sheet.

param

Use start of feed information

Check this field to send the data specified on the 'Start of feed' dialog, before the receive report is sent.

param

Use end of feed information

Check this field to send the data specified on the 'End of feed' dialog, after the receive report is sent.

param

Report Text

Use this field to specify the contents of the receive report. You can enter a combination of text and environment variables. Please refer to the on-line documentation for a description, and complete list of available server variables.

Variables: $PORTNAME, $SERVERNAME, $RECVBYTES, $RECVLINES, $RECVERRORS, $RECVERRTEXT, $RECVLPS, $RECVCPS, $RECVPRGNAME, $RECVFILENAME, $RECVDIRNAME and $RECVPATH.

If 'Send in comments' and/or 'Send with Block numbers' is selected, you can disable them on any line by adding a ! at the start of the line.

Receive report example: