DNC/CNC reports many errors

Problem: When trying to send data between the DNC server and the CNC, the server reports lots of errors, but the data looks okay.

This is most likely caused by incorrect parity and data bit settings.

1. Parity problem

Check that you have selected the correct parity type (Even, Odd, ...).

Refer to the RS232 setup page in your control or to the CNC's manual for further information.

2. Check that you are using the correct number of data bits

Refer to the RS232 setup page in your control or to the CNC's manual for further information.

3. Check that you are using the correct number of stop bits

Refer to the RS232 setup page in your control or to the CNC's manual for further information.